Jump to content

Gmt900 Mod Link Thread

splat10
 Share

Recommended Posts

splat10 Enthusiast

splat10

Posted
Posted

Can Some of you Super-modders post up links to the best mods here in just a summary format the puts it all in one place. This way it could potentially be pinned and make a real good reference.

 

Thanks

  • Like 1
  • Replies 97
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

splat10
splat10

I'll start:   Steering Wheel Radio Controls Add On: http://www.gm-trucks.com/forums/index.php?showtopic=69369 http://www.gm-trucks.com/forums/index.php?showtopic=69054 http://www.gm-trucks.com/fo

trucc_boi
trucc_boi

antenna delete mod

Brian66D
Brian66D

EZ down tailgate assist.....   best 30 bucks I've ever spent.

splat10 Enthusiast

splat10

Posted
  • Author
Posted (edited)

I'll start:

 

Steering Wheel Radio Controls Add On:

http://www.gm-trucks.com/forums/index.php?showtopic=69369

http://www.gm-trucks.com/forums/index.php?showtopic=69054

http://www.gm-trucks.com/forums/index.php?...100236&st=0 (make your own harness)

Complete Wheel Part Numbers

15917933 is the steering wheel with TITANIUM inserts

15917931 is the wheel with the BLACK inserts

 

Add-a-DIC-tome

http://www.gm-trucks.com/forums/index.php?showtopic=63291

http://www.gm-trucks.com/forums/index.php?showtopic=113704

Full Panel - 19159438

Switch only - 15947841

 

Adding a Cargo Light switch

http://www.gm-trucks.com/forums/index.php?showtopic=107730

 

Adding a Center Console - Part Numbers

http://www.gm-trucks.com/forums/index.php?...st&p=634172

Edited by splat10
  • Like 2
lsuguy Senior Enthusiast

lsuguy

Posted
Posted (edited)

Not on this site but good writeup:

How to remove/replace GMC GMT900 grill

 

 

http://www.truckmodcentral.com/forums/showthread.php?t=1091

http://www.truckmodcentral.com/forums/show...t=billet+grille

 

GMT900 Projector Headlight Writeup

 

http://www.gm-trucks.com/forums/index.php?...mp;hl=headlight

 

Bed Underrail Lighting

 

http://www.gm-trucks.com/forums/index.php?showtopic=93508

 

Custom Sheet Metal Gap Guards

 

http://www.gm-trucks.com/forums/index.php?...=81181&st=0

 

Install/Change door handles

 

http://www.gmfullsize.com/forum/showthread.php?t=93769

Edited by LSU_Dark_Knight
Overclock Enthusiast

Overclock

Posted
Posted

There should be one post that has all the links in it for easy reference

Even this thread could work if the original post gets updated.

 

What I'd like to see is a clear cut post about adding factory foglights to a Sierra including part numbers and perhaps even wiring instructions.

This would be right up there with the "add a DIC" mod

splat10 Enthusiast

splat10

Posted
  • Author
Posted

once we get a good list then we can cut and paste them all into one post and ask the mods to pin it. Post #3 is all about fog lights. I haven't read it because i have fog lights on my z71 but it lookes like the info needed is right here.

lsuguy Senior Enthusiast

lsuguy

Posted
Posted

Well it's been pinned so go ahead and start updating your original post.

 

As far as adding fog lights to the Sierra, that write up above is for Silverado's as far as I know. Installation on the Sierra's should be really easy and wiring should be the same as the Silverado's wiring.

Overclock Enthusiast

Overclock

Posted
Posted
Well it's been pinned so go ahead and start updating your original post.

 

As far as adding fog lights to the Sierra, that write up above is for Silverado's as far as I know. Installation on the Sierra's should be really easy and wiring should be the same as the Silverado's wiring.

 

Yes, wiring should be the same.

Part numbers would be perfect.

If I tackle this project before this thread gets updated; I'll post the info myself but i'm hoping someone that has done this already could update.

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • newdude
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By newdude · Posted

      No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • jaszr2
      Active Grille Delete

      By jaszr2 · Posted

      Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
    • devonthegreat
      anyone interested in a 2002 Chevy Silverado 4x4 parts truck NYC

      By devonthegreat · Posted

      **SOLD** Please end or delete post. thank you
    • PBNB
      Tire pressure for 37s

      By PBNB · Posted

      Do you think this width might affect the chalk test with a higher pressure closer to 65psi? I think lowering the pressure makes sense to get the tread to lay flatter

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...